Speed Ramp Bundles

Allpark Ltd offer two different types of speed ramp:

Economy

Manufactured from 100% recycled PVC with integral locking facility for ease of siting and installation. Each yellow and black section has white reflectors incorporated within the leading edge. Also features an underside channel allowing for hose and/or cables to be located within.

Premium

The premium speed bumps are manufactured from NON RECYCLED RUBBER AND RUBBER COMPOUNDS. Available in black and yellow colours, the yellow is not painted on but yellow rubber compound comressed to the ramp. The 4mph speed bump comes with male/female lugs for interlocking to provide stronger fixing.

Each bundle comes with the correct number of bolts for easy surface fixing. It is important to use the correct type of bolt on either concrete or tarmac.

The bundles include:

3 Metre Bundle has 5 mid sections, a pair of end caps and 24 concrete or tarmac bolts

4 Metre Bundle has 7 mid sections, a pair of end caps and 32 concrete or tarmac bolts

5 Metre Bundle has 9 mid sections, a pari fo end caps and 40 concrete or tarmac bolts

This product is usually delivered within three working days. Where instances of high demand are occurring a member of our sales team will contact you and advise of any longer lead times.

Installation:

The speed ramp product can be installed by using two methods of fixing a) surface mounted by bolting down with rubber expanding bolts or b) laying a concrete raft and fixing with anchor bolts.

Asphalt surface mounting for speed ramps, speed bumps and all types of traffic calming:

This method should only be used if the asphalt surface is older than 6 months and has a crust of asphalt depth of 50mm or greater.

The benefits of using rubber bolts are that they offer a “dampening” effect when traffic passes over. Rubber fixing plugs have an outside diameter of 22mm and are 75mm in depth, the actual bolt size is an M12 x 100mm.

The product should be laid in desired location, drill hole area should then be marked out. All holes should be drilled prior installation, do not fit the product until all of the surface holes have been drilled out.

Important note: The rubber plugs and fixing bolt should be fitted to the product prior being dropped into location. Once the bolts have been loosely fitted drop the entire unit into the pre-drilled holes, you will save hours of time!

Fitting a concrete raft:

This method should be used if the road surface is in poor condition, is newer than six months old or has a asphalt surface depth of less than 50mm.

A concrete foundation/slab should be laid, reinforcing should not be used. Once the concrete has set the product should be fitted as per the diagram below.

Marking and setting out:

Ensure that no drains, hydrants or service outlets will be covered. Set out the gap width between kerb and the end cap. This is typically advised at 200mm and would allow future works to the pavement without disturbance to the speed ramp if required in the future. Mark out the edge in chalk on the road surface. Position the end cap from the edge line and lay out the Speed ramps in a straight line. Position the modules and end cap, crossing the road. Spot mark and remove.

Replace end caps, modules and check that the alignment is straight with a plumb line.

Equipment & Tools required for installation:

1. 2.2 kva generator.
2. T14 Hammer Drill.
3. Drill bits (two recommended).
4. 110 volt 25 metre extension lead.
5. 110 volt junction box.
6. 110 volt impact wrench ½ drive c/w 17mm socket (optional).
7. 100 psi portable compressor c/w hose and long air gun.
8. 7lb sledge hammer.
9. 2lb ball pin hammer.
10. 20 metres measuring tape (cloth type).
11. Hand operated ratchet ½ inch drive c/w 17mm long reach socket.
12. Stiff broom.
13. Chalk.
.

Alternatively please contact a member of our sales team to discuss our nationwide installation teams!